The patrol inspection content of battery

1, the dc bus voltage should be normal. Battery tester is dedicated to the daily maintenance of the backward monomer battery processing of portable products, it has the use of three separate ways: battery discharge way, the way the battery and battery activation. Can according to the actual situation of different behind the battery, for behind the battery capacity test, low pressure constant current charging, or set up multiple cycle loop of minimum capacity of the battery charge and discharge for many times, in order to fuel battery plate failure of the active material make the cell activation, enhance behind the capacity of the battery. Battery tester, when using the nimh battery or lithium battery in the tester under test, the indicators set, for testing, can test out the battery voltage, internal resistance, capacity, charge, discharge, over current, short circuit protection. After completion of the test, press the "print" button, you can by small printer to print out a similar rent ticket inspection report, the report can be displayed on the cell type, voltage, capacity, detection units, time, and whether or not qualified. Intelligent battery activation instrument with the use of three separate ways: battery discharge way, the way the battery and battery activation. Can according to the actual situation of different behind the battery, for behind the battery capacity test, intelligent charging, or set up multiple cycle times please charge and discharge cycle, with fuel battery plate failure of the active material makes cell activation, enhance behind the capacity of the battery. Float charging flow (Electron flow should be appropriate, without charge or owe charging phenomenon:

2 measure various parameters (parameter). Float charging, the Battery voltage (') should be kept in 2. 1 ~ 2.2 V, charge and discharge voltage shall be not less than 1.8 ~ 1.9 V, the proportion of the electrolyte should be between 1.215 ~ 1.229, the liquid temperature should be kept between 150 ~ 350 c,

3 patrol plate color is normal, do you have any fault (fracture), folding, short circuit (direct current without using electrical appliances, even the power poles) and effective content drops wait for a phenomenon,

4 wooden partition, lead (appearance: bluish silvery white) clamp shall be complete, no fall off phenomenon,

5 level should be higher than plate 10 ~ 20 mm,

6 Battery (') shell should be complete, no tilt, surface should be clean,

7 each joint connection should tighten, no corrupt erosion phenomenon and coated with vaseline,

8 floating device (offerings) normal operation,

9 dc system (system) (insulated) insulation is good,

10 for alkaline (alkaline) batteries (') should also check screw cap is good, air flow should be clear.

11 ventilation and its ancillary equipment should be in good condition, indoor without strong smell, Battery ('), room temperature (temperature) should be between 100 ~ 300 c,