Battery monomer activation instrument common problems

When using battery monomer activation instrument sometimes have some problems, the following is the use of several common problems in the process of the solution:

A, after startup

The power did not answer. Battery load tester host built-in memory, read U disk storage records are available, and do not need to carry the computer, single machine can work, printing report which with a computer in the future, but with a fixed voltage current calibration function, may at any time for instrument calibration correction measurements, guarantee the accuracy of measurement. Please inspect battery monomer activation instrument power plug is good. Terminal line to pressure. The host menu control the normal operation, an external signal

Loose host poor contact (line), please inspect the contact is reliable. Button failure or confusion

Please inspect if there is a key stuck not up, if you have to make it up to resume normal work. Using activation can be N separate charging and discharging

For single charge and discharge time shall not exceed 18 hours, if need to charge and discharge time alone more than 18 hours with activation (continue) to increase the time N cycle. Battery internal resistance tester is the instrument through online testing, and can display and record of the single or multiple sets of batteries voltage, internal resistance, capacity and other important parameters, effectively carry out behind the battery, and with the computer and battery test report data management software, followed the trend of decay, and providing maintenance advice. Apply to the communication base station, transformer substation, UPS battery maintenance inspection. Used for battery acceptance, storage battery group and routine inspection. Battery tester, when using the nimh battery or lithium battery in the tester under test, the indicators set, for testing, can test out the battery voltage, internal resistance, capacity, charge, discharge, over current, short circuit protection. After completion of the test, press the "print" button, you can by small printer to print out a similar rent ticket inspection report, the report can be displayed on the cell type, voltage, capacity, detection units, time, and whether or not qualified. Example: if you want to charge time is 28 hours, set the activation cycles for two times, first time charging time for 18 hours, discharge time is 0, the second charge time for 10 hours, discharge time is 0. Discharge method again, this time charging time should be 0.

Battery set

Battery input a number four. For the convenience of management, the former two set for the group, after the two set to battery, there can be a maximum of 99 groups, within the same set up battery number is 99. Write to U disk error

1, see the U disk inserted;

2, see if 0 plate properties of FAT format, if not, please use FAT format the U disk.

3, if in the process of read U disk error or long time no response, please try again to use FAT format the U disk,